anyone got a photo of what a properly dissolved vial looks like
#reconstitution 2025-06-03
for the archive 5mg in 2ml gives 2.5mg/ml, 0.25mg is 10 units. good for a starting dose
does temperature of the bac water matter at all
it should be completely clear with no floaters. cloudy means stop
if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way
you can absolutely just always use 2ml, and honestly most of us should
the last few units are a real loss. i accept it rather than tilting the vial and drawing air
nobody here should be telling you a dose. we can check your arithmetic, thats a different thing
*that should say weekly
weigh it first
if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way
does it matter if i inject the bac water straight at the powder
15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it
first vial arrived. 5mg. i am supposed to be taking 250mcg
so that is 250 out of 5000, one twentieth of the vial
correct so far
i put 5ml in, so a twentieth of 5ml is 0.25ml. 25 units?
the arithmetic is right and the recon volume is wrong
wrong how, 25 is a nice round number
5ml into a 5mg vial gives you 1mg/ml. that is a lot of water for a starting dose
you will be pushing 0.25ml in every week, and by the time you reach 1mg you are injecting a quarter of the vial in one go
also a 5mg vial usually will not physically hold 5ml
...it holds 3ml maybe
*it says 3ml on the glass
there it is
put 1ml in. 5mg/ml. 250mcg is 0.05ml, which is 5 units
0.05ml feels like nothing
it is nothing. that is the point. the drug is potent and the water is only a carrier
leaving this here because it comes up weekly: mcg and mg are a thousand apart and people type them interchangeably
if a number looks a thousand times off, it usually is
i did write 250mg in my own notes earlier
*250mcg not mg. obviously
the other thing nobody warns you about is the needle hub
if you draw up with one pin and inject with another, whatever is sitting in the hub does not go in you
on a fixed-needle insulin syringe the dead space is tiny. on a luer hub it is not tiny at these volumes
which is why most of us use a plain u100 insulin syringe and accept the blunter draw-up
so one syringe, draw and inject with the same thing
yes. cheaper as well
over-dilution has a measurement side too. the fewer units you draw, the bigger a half-unit error is in percent
5 units, half a unit out, that is 10% of your dose
50 units, half a unit out, that is 1%
so the answer to your original question is 5 units and not 25, and the reason is the vial, not the maths
got there eventually
photo of the 3ml graduation on the glass, for anyone who has not held one yet
thanks. mixing properly this time