is there any reason not to just always use 2ml
#reconstitution 2025-07-03
Thursday16 messages4 participantstimes are UTC
Highlights from this day
- power_through_no — 15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it, thats one data point 15:26
- lyophile_liv — im getting bubbles in the barrel every single time, what am i doing wrong 15:34
- vienna_vial — i have never once regretted using a rounder number and a slightly bigger volume i swirl for about thirty seconds and then leave it. never had one fail to dissolve 16:19
- vienna_vial — if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space 16:49
- power_through_no — nobody here should be telling you a dose. we can check your arithmetic, thats a different thing 18:53
bacteriostatic water for anything multi-use. sterile water has no preservative in it at all
it foamed. is it ruined
15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it, thats one data point
🔥11
write the date on
one unit is 0.01ml
5mg in 2ml gives 2.5mg/ml, 0.25mg is 10 units. good for a starting dose
the powder is stuck to the stopper, do i care
bac water or sterile water for something im going into weekly for 6 weeks
is it normal for the cake to look slightly collapsed on one side
im getting bubbles in the barrel every single time, what am i doing wrong
medutest-report-kp-0925.pdf
3 pages · 880 KB · not retained in the public archive
i have never once regretted using a rounder number and a slightly bigger volume
i swirl for about thirty seconds and then leave it. never had one fail to dissolve
if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space
does benzyl alcohol matter if im finishing the vial in one go
label the date too. you will not remember which vial is which by week 27
nobody here should be telling you a dose. we can check your arithmetic, thats a different thing
[edited]